The Lectrosonics UH200C is a synthesized UHF plug-on transmitter compatible with all receivers in the 200 Series product group. In addition to common uses with hand-held microphones, the multi-voltage phantom power feature allows the transmitter to be used with high current condenser microphones, expanding its usefulness in high-end applications such as motion picture production. The transmitter provides 256 frequencies in standard Lectro frequency blocks, selected with two rotary switches on the side of the housing.
FEATURES:
Digital Hybrid Wireless Technology
Converts Microphones With XLR Jacks To Wireless Operation
Selectable 5, 15 And 48 Volt Phantom Power Plus Off Position
256 Synthesized UHF Frequencies
100 Mw Output Power
Dual Envelope Input Limiter
Dual Bicolor Leds Indicate Four Different Levels For Accurate Gain Adjustment
Dsp Based Pilot-Tone Signal
Isolator Protected Output Stage
Rugged Machined Aluminum Housing
Compatible With 100, 200 Or 400 Series Lectrosonics Receivers
Also Known As: Butt Plug
Operating frequencies: 470.100 to 607.900 MHz; 614.100 to 767.900 MHz
Frequency selection: 256 frequencies in 100 kHz steps
RF Power output: 100 mW
Pilot tone: 25 to 32 kHz; 5 kHz deviation
Frequency stability: +/- 0.002%
Deviation: +/- 75 kHz max
Spurious radiation: 60 dB below carrier
Equivalent input noise: +/-118 dBV, A-weighted
Input level: Nominal 2 mV to 300 mV, before limiting; Greater than 1.0 V maximum, with limiting
Input impedance: 1 k Ohm
Phantom power: Selectable; 5, 15, 48 VD
Input limiter: Soft limiter, >30 dB range
Gain control range: 43 dB; semi-log rotary control
Modulation indicators: Dual bi-color LEDs indicate modulation of +/-20, -10, 0 and +10 dB referenced to full modulation
Low frequency roll-off: +/-12 dB/octave; 70 Hz
Controls: Control panel knob adjusts audio gain
Rotary switches on bottom panel adjust transmitter frequency
Audio Frequency Response: 90 Hz to 20 kHz, +/-1 dB
Signal to Noise Ratio (dB):
Note: The dual envelope “soft” limiter provides exceptionally good handling of transients using variable attack and release time constants. Once activated, the limiter compresses 30+ dB of transmitter input range into 4.5 dB of receiver output range, thus reducing the measured figure for SNR without limiting by 4.5 dB
Total Harmonic Distortion: 0.2% typical
Antenna: Built-in; housing and input coupler form a dipole configuration
Battery Type: 9V Li Polymer rechargeable, Lithium
Battery Life: 4.5 Hours with alkaline or Li Polymer, 12 hrs with lithium
(Battery life will vary with battery brand, phantom power voltage setting and mic current drain.)
Emission Designator: 190KF3E
SIZE:
Not Including Mic:
1.6″ x 1.6″ x 4.2″
38.1 x 38.1 x 106.68 mm
LECTROSONICS PLUG ON TRANSMITTER UH200C
Call for Price - Day Rate
The Lectrosonics UH200C is a synthesized UHF plug-on transmitter compatible with all receivers in the 200 Series product group. In addition to common uses with hand-held microphones, the multi-voltage phantom power feature allows the transmitter to be used with high current condenser microphones, expanding its usefulness in high-end applications such as motion picture production. The transmitter provides 256 frequencies in standard Lectro frequency blocks, selected with two rotary switches on the side of the housing.
FEATURES:
Digital Hybrid Wireless Technology
Converts Microphones With XLR Jacks To Wireless Operation
Selectable 5, 15 And 48 Volt Phantom Power Plus Off Position
256 Synthesized UHF Frequencies
100 Mw Output Power
Dual Envelope Input Limiter
Dual Bicolor Leds Indicate Four Different Levels For Accurate Gain Adjustment
Dsp Based Pilot-Tone Signal
Isolator Protected Output Stage
Rugged Machined Aluminum Housing
Compatible With 100, 200 Or 400 Series Lectrosonics Receivers
Also Known As: Butt Plug
Product Manuals
Specifications
Operating frequencies: 470.100 to 607.900 MHz; 614.100 to 767.900 MHz
Frequency selection: 256 frequencies in 100 kHz steps
RF Power output: 100 mW
Pilot tone: 25 to 32 kHz; 5 kHz deviation
Frequency stability: +/- 0.002%
Deviation: +/- 75 kHz max
Spurious radiation: 60 dB below carrier
Equivalent input noise: +/-118 dBV, A-weighted
Input level: Nominal 2 mV to 300 mV, before limiting; Greater than 1.0 V maximum, with limiting
Input impedance: 1 k Ohm
Phantom power: Selectable; 5, 15, 48 VD
Input limiter: Soft limiter, >30 dB range
Gain control range: 43 dB; semi-log rotary control
Modulation indicators: Dual bi-color LEDs indicate modulation of +/-20, -10, 0 and +10 dB referenced to full modulation
Low frequency roll-off: +/-12 dB/octave; 70 Hz
Controls: Control panel knob adjusts audio gain
Rotary switches on bottom panel adjust transmitter frequency
Audio Frequency Response: 90 Hz to 20 kHz, +/-1 dB
Signal to Noise Ratio (dB):
Note: The dual envelope “soft” limiter provides exceptionally good handling of transients using variable attack and release time constants. Once activated, the limiter compresses 30+ dB of transmitter input range into 4.5 dB of receiver output range, thus reducing the measured figure for SNR without limiting by 4.5 dB
Total Harmonic Distortion: 0.2% typical
Antenna: Built-in; housing and input coupler form a dipole configuration
Battery Type: 9V Li Polymer rechargeable, Lithium
Battery Life: 4.5 Hours with alkaline or Li Polymer, 12 hrs with lithium
(Battery life will vary with battery brand, phantom power voltage setting and mic current drain.)
Emission Designator: 190KF3E
SIZE:
Not Including Mic:
1.6″ x 1.6″ x 4.2″
38.1 x 38.1 x 106.68 mm
WEIGHT:
Not Including Mic:
0.41 lb. (0.2 kg)
Related products
SANKEN COS-11D LAVALIER MIC
Call for Price - Day Rate Call for PriceLECTROSONICS RECEIVER UCR211
Call for Price - Day Rate Call for PriceCOUNTRYMAN B6
Call for Price - Day Rate Call for Price